7
Self-Contained Spot Merchandiser
5 foot section). The discharge air sensor is located inside the rear discharge air duct. The settings for low temperature
and medium temperature are preset in the electronic controller and no adjustment is required after connecting power
to the merchandiser.
CAUTIONS:
•
Air discharge and return flues must remain open and free of debris or obstructions at all times to provide proper
refrigeration and air curtain performance.
•
Do not allow any product, signs, debris, etc., to block return air grills.
•
Do not use any non-approved shelving, display racks, or any accessory that could disrupt air curtain perfor-
mance.
NOTE:
Electric defrost is standard on these models and evaporator fans run continuously.
4.1. Cleaning
As a general rule, always use mild soap and water to clean the merchandiser. Special precautions must be taken
when cleaning some components of the merchandiser.
Exterior surfaces should be cleaned with warm water and mild soap to protect and maintain the finish. Do not use
cleaners containing abrasive materials or ammonia that will scratch or dull the finish. The waste outlet should be
flushed with water following each cleaning.
Interior surfaces may be cleaned with most mild soap formulas, ammonia based cleaners, and sanitizing solutions
with no harm to the surface.
WARNING!
ALWAYS DISCONNECT POWER DURING THE CLEANING PROCESS. CLEANING THE
MERCHANDISER WITH ELECTRICAL POWER APPLIED IS A SHOCK HAZARD THAT MAY CAUSE
SERIOUS INJURY OR DEATH.
CAUTION:
DO NOT USE HOT WATER ON COLD GLASS SURFACES. This could cause the glass to shatter and
result in personal injury. Glass fronts and ends should be warm before applying hot water.
Do not use materials or methods listed below to clean the merchandiser. The warranty will be voided if these products
or cleaning methods are used that causes rust to form on the stainless steel surfaces or any other parts of the
equipment.
•
On unpainted stainless steel surfaces (they may cause rust to form), products containing:
•
Chlorine
•
Chloride ion
•
Any cleaner containing bleach
•
On any interior surfaces because the surface may become damaged:
•
Solvents
•
Oils
•
Acidic-based cleaners
•
Abrasive cleaners and scouring pads because these will mar the finish
•
Steam or high pressure systems to clean the merchandiser because seals may be broken resulting in leaks
To ensure minimum maintenance cost, the merchandiser should be emptied and thoroughly cleaned every three
months. The exterior should be cleaned weekly. The waste outlet should also be checked and cleaned weekly.
Follow the previous general cleaning of the interior and exterior parts. Do not use a water hose to clean the
evaporator or tub of the merchandiser.
