4
200477-02
OPTIONAL WIRING
This fixture is provided with a sensor rated for 360 Watts. Since the fixture is only rated 100
Watts (180 Watts candelabra), 260 Watts (180 Watts candelabra) of additional load may be
controlled by this sensor.
When determining what a fixture is rated for, do not simply look at the rating on the lamp in
the fixture. Look at the marking which specifies the maximum lamp wattage for which the
fixture is suitable.
Once you have selected the fixtures to be connected and determined their maximum ratings,
add these ratings up. For instance, if you have 3 fixtures rated 100 Watts, 150 Watts, and
75 Watts respectively, you have a total load of 325 Watts.
Wiring Diagram 1 – When wiring to control a standard light fixture: Strip the motion
sensor’s
red wire and connect to the standard light’s black wire. Connect all white wires
together. Total fixture ratings must not exceed 360 Watts (3.0 A).
Wiring Diagram 2 – When wiring to control another motion sensing light fixture (Master
/ Slave): Strip the red wire in both light fixtures. Connect the red wire of the controlling
(master) fixture to the
red and black wires of the controlled (slave) fixture. Connect all
white wires together. Total fixture ratings must not exceed 360 Watts (3.0 A).
Wiring Diagram 3 – When wiring so either motion light turns on both motion lights
(Master / Master): Strip the red wire in both light fixtures. Connect the red wire of one
fixture to the
red wire of the second fixture. Note: In most installations, an additional wire
(same gauge as existing house wire) will have to be installed in the house to connect
the two fixtures as master / master. Connect all white wires together and all black wires
together. Total fixture ratings must not exceed 360 Watts (3.0 A).
Wiring Diagram 1
Wiring Diagram 3
Black
Black
White
White
Green
or Bare
Green
or Bare
Light
Fixture
Light
Fixture
Light
Fixture
Light
Fixture
Wiring Diagram 2
(Standard)
Master
Master
Master
Slave
Black
White
Green
or Bare
Light
Fixture
Light
Fixture
Red
Red
Red
