© 2012 HeathCo LLC
203017-02A
Model 5596
Motion Sensor Light
Control
This package includes:
Light Control
Sensor
Cover
Plate
Bulb Holders
Plastic Hanger
Rubber Plug
Gasket
6 Screws
(3 sizes included)
Mounting Strap
Mounting Bolt
2 Wire
Connectors
Features
• Turns on lighting when motion is detected.
• Automatically turns lighting off.
• Three lamp modes available: Security, BulbSaver,
or AlertFlash.
•
D
ual
B
rite
®
Timer.
• Photocell keeps the lighting off during daylight hours.
• LED indicates motion was sensed (day or night).
• Note for CFL bulb users: Dimmable CFL bulbs required.
TEST
TEST 1 5 20
ON-TIME
Off 3 6 Dusk to
Dawn
D
ual
B
rite
®
Put ON-TIME switch
on the sensor bottom
to TEST and the
D
ual
-
B
rite
®
switch OFF.
OPERATION
* resets to Auto Mode at dawn.
ON-TIME
TEST
1 5 20
AUTO
Note: When first turned on wait about 1
1
/
2
minutes for
the circuitry to calibrate.
Requirements
• The light control requires 120-volts AC.
• If you want to use Manual Mode, the control must be
wired through a switch.
•
Some codes require installation by a qualified
electrician.
• This product is intended for use with the enclosed
gasket and with a junction box marked for use in wet
locations.
Mode:
On-Time:
Works: Day Night
Test
5 Seconds
x
x
Normal
1, 5, 20 minutes
x
Manual
Until Dawn*
x
Accent Off, 3, 6 Hr. to Dawn
x
LAMP MODE
NORMAL SOFT FLASH
LAMP MODE
Put the LAMP MODE
switch in the Security
(“Normal”), BulbSaver
(“Soft”), or AlertFlash
(“Flash”) position.
Put the ON-TIME switch in
the 1, 5, or 20 minute position.
2 Lamps
(installed)
