2
598-1305-04
Angled 50°
2.
Mount Light Fixture.
Attach the battery case to a
solid surface using two round-head screws and the
keyholes on the back of the case.
6
3
/
4
"
Mounting
Holes (2)
4. Plug the solar panel cable into the bottom of the
battery case.
IMPORTANT:
allow the battery to
charge with 3 to 7 days of full sunshine before
testing. to verify battery is charged, slide the On-
tIMe switch to teSt. If light comes on, battery is
charged and ready for use. If light does not come
on, slide the On-tIMe to OFF. recheck the light
the next day.
Controls
Light
Battery Case
sensor Joint
Clamp
IMPORTANT:
the controls must face downward to
avoid damage from rain.
If controls face upward, move
sensor to the original down position, rotate 180°, then
raise to the position shown below.
Light Joint Clamps
Lens Removal
Tab
sensor
Wall Mounted Light
Do not Mount under eaves
Note:
Light fixture and sensor should be mounted as
shown above when installed (depending upon type of
installation).
3.
adjust sensor.
For proper operation, the sensor
head must be rotated so that the sensor controls face
downward as shown below.
solar Panel
solar Panel
Wire
Light Fixture
Mounted Solar Panel
Note:
solar panel should be mounted as shown above
when installed (depending upon type of installation).
roof Mount
Wall Mount
