background image

This chime requires 2 “C” alkaline batteries (not included). In typical use, 
alkaline batteries will last up to one year.

Wireless Chime

© 2016 HeathCo LLC 

Figure 2

Figure 1

 WARNING: To prevent possible 

SERIOUS INJURY or DEATH:

• NEVER allow small children near

batteries.

• If battery is swallowed, immediately

notify doctor.

This package includes (Style of door sensor and chime may vary from illustration):

1. Remove orange battery tab from push

button. Remove back of case by pushing in
tab on bottom with a small screwdriver (see
Figure 1). Remove orange battery tab.

2. Remove chime cover. Firmly pull on cover

to remove it from chime base (see Figure 2).

Chime 

base

Chime cover

Wireless push 

button

Hardware 

pack

Model

TYPE

 'C

'

LR14

TYPE

 'C

'

LR14

MODEL:

 WL-102D

UP

SYNC – HOLD 3 SECONDS

RESET – HOLD 10 SECOND

S

7868

7870

7871

TR-0095-RX

TYPE

C

Summary of Contents for 7868

Page 1: ...ctor This package includes Style of door sensor and chime may vary from illustration 1 Remove orange battery tab from push button Remove back of case by pushing in tab on bottom with a small screwdriver see Figure 1 Remove orange battery tab 2 Remove chime cover Firmly pull on cover to remove it from chime base see Figure 2 Chime base Chime cover Wireless push button Hardware pack Model TYPE C LR1...

Page 2: ...shing in tab on bottom with a small screwdriver see Figure 1 Note Remove material in screw holes if needed before mounting with screws Attach back of case to door jamb or wall see Figure 5 Snap front of push button on Tape Mounting When attaching push but ton using double sided tape make sure the surface of the door jamb or wall is clean 6 Mount chime base Determine mounting location Place chime a...

Page 3: ...ttons are used Troubleshooting 1 PROBLEM Chime does not sound A POSSIBLE CAUSE Batteries not installed correctly A CORRECTIVE ACTION Make sure batteries are installed according to the diagram inside the push button and chime B POSSIBLE CAUSE Batteries are dead B CORRECTIVE ACTION Check charge of push button and chime bat teries and replace if necessary C POSSIBLE CAUSE Push button and chime are no...

Page 4: ...ing interference from another wire less device CORRECTIVE ACTION Reset chime and push button Remove push button batteries Wait 30 seconds Press and hold the push button for 10 to 15 seconds within 60 seconds after installing battery into the push button Press and hold the button on the chime until the chime sounds a Beep Beep Beep Beep To re sync the push button and chime press and hold the button...

Reviews: