3
598-1116-00
DRAFT COPY
Channel Settings
Note: Most installations will not require you to change any of the dip
switches on your plug-in module or remote control.
The remote control communicates
by using channels that can be
changed by sliding dip switches into
the ON or OFF [on some switches
the numbers 1 (ON) and/or 0 (OFF)
are used] position on the remote
control. The channel is factory set;
however, there are 3 switches (8
selectable channels) that allow you
to expand your system and prevent
outside interference. Other wireless
products may cause interference
and the system may not function properly. Follow the instructions below for
setting a new channel.
1. Open the cases and locate dip switches on both the remote control and
outdoor module (see Figure 5).
2. The remote control and outdoor module both have two positions (ON and
OFF) on each of the four dip switches. Dip switches 1 through 3 are used for
setting the channel. Position 4 is not used and must remain in OFF position.
3. To change the channel, slide dip switches to ON or OFF as needed. It is
recommended to only change one dip switch at a time and then check to see
if system is functioning properly. Note: Dip switches in positions 1 through
3 must be in the exact same configuration on both the remote control and the
device it is intended to operate to function properly.
Dip Switches - Shown
in the OFF Position
(Factory Default)
ON
1 2 3 4
ON
1 2 3 4
Figure 5
