12
Heatilator • CNXT4236IFT, CNXT4842IFT Owner’s Manual • 2515-981 Rev. L
• 12/20
G. Appliance Break-In
Follow the initial break-in procedure below to cure the
materials used to manufacture the fireplace and the
finishing materials around it.
• The fireplace should be run three to four hours
continuously on high.
• Turn the fireplace off and allow it to cool completely.
• Remove fixed glass assembly. See Section 4.B.
• Clean fixed glass assembly. See Section 4.B.
• Replace the fixed glass assembly and run continuously
on high an additional 12 hours.
NOTICE!
In some cases, residue may appear on the
top fiber refractory piece at the end of the initial break-in
period. Remove the residue by gently brushing with a
soft-bristle brush.
Note:
The IntelliFire Touch
®
system has a safety feature
that automatically shuts down the fireplace after 9 hours
of continuous operation without receiving a command from
the remote control. If this occurs, restart the appliance.
NOTICE!
Open windows for air circulation during fire
-
place break-in.
• Some people may be sensitive to smoke and odors.
• Smoke detectors may activate.
H. Heat Management
Heat Output
• Heat output may be controlled on these models by
adjusting the “Flame Height” setting on the remote
control.
• Fan speed may be controlled using the “Fan Speed”
setting on the remote control.
