28881 Rev G
16
01-02
NOVUS REAR DIRECT VENT
Figure 23
Figure 24
d. Assembling the Slip Sections
Slip sections should be snapped into the first
mating piece, then expanded to their desired
length, making sure that a 1.5 overlap is
maintained between the twp sections of the slip
section. The sections need to be secured by
driving two screws through the overlapping
portions of the vent. See Figure 23. This will
secure the slip section to the desired length and
prevent it from separating. The slip section can
then be attached to the next section of vent.
e. Disassembling Vent Sections
(Only if necessary)
To disassemble any two pieces of pipe, rotate
either section so that the seams on both pipe
sections are aligned as shown in Figure 24. They
can then be carefully pulled apart.
All manuals and user guides at all-guides.com
all-guides.com
