1. PRODUCT DESCRIPTION
The Heatit Leakage Stopper is a motor to retrofit existing and installed
ball valves into smart water controlling devices. The motor is powered
by a 12V external power supply or - optionally – a battery block.
The adjustable clamps allow for mounting the device even in complex
pipe installations, and the patented motor coupling ensures easy
installation and precise long-term operation. The device can operate
in difficult environmental conditions, even submerged in water, and
supports a direct connection of one additional local water sensor pad
via cable.
The device can operate in two modes:
Stand-Alone
No further wireless connectivity is needed. A single
click of the button opens and closes the valve. Clicking the button
during open or close operation stops the movement. The next click
will continue the operation. Escaping water is detected by the external
sensor pad and the valve it shut off accordingly. The button on the
device allows cancelling the alarm. A device in factory reset state
operates in stand-alone mode without further configuration.
Z-Wave Network Mode
The device is added to a Z-Wave network as
Z-Wave Binary Switch Device. Adding can be done by using SmartStart
or manual Z-Wave inclusion. All functions of the Stand-Alone mode
remain active. Leakage or temperature alarms are forwarded to the
Z-Wave gateway and other Z-Wave device are able to control the
motor.
2. STATEMENT REGARDING PRODUCTS FROM MULTIPLE
MANUFACTURERS
Please read this before installation
This device may be used with all devices certified with the Z-Wave
Plus™ certificate and should be compatible with such devices
produced by any manufacturer. Every primary controller is different
depending on the manufacturer, their target audience and intended
use/application. Please review the functionalities implemented by the
primary controller you intend to use with our Z-Wave Plus certified
device to ensure that it provides the necessary controls to take full
advantage of our product’s capabilities.
3. BEHAVIOUR WITHIN THE Z-WAVE™ NETWORK
This device may be operated within any Z-Wave network with
Z-Wave-certified devices from other manufacturers. All non-battery-
operated nodes within the network will act as repeaters regardless of
manufacturer to increase the reliability of the network. On delivery, the
device does not belong to any Z-Wave network.
The device needs to be added to an existing network to communicate
with the other devices within it. Devices may also be removed from
a network. The add/remove processes are initiated by the primary
controller of the Z-Wave network.
HEATIT
LEAKAGE
STOPPER
Ver 2021-A
Firmware 5.3
01.06.2021
Installers manual
TABLE OF CONTENT
1. Product description
2. Statement regarding products from multiple
manufacturers
3. Behaviour within the Z-Wave™ Network
4. Calibration
5. Prepare for installation / Reset
5.1
Factory Reset
6. Installation
7. Add/Remove
7.1
Meth
od 1: Standard (Manual)
7.2
Meth
od 2: SmartStart (Automatic)
7.3
Remo
ve
8. Operating the device
8.1
Button features
8.2
Local or remote open and close of the valve
8.3
Local alarm
8.4
Local sensors
9. Quick trouble shooting
10. Node Information Frame
11. Security
12. Association - one device controls other devices
13.1
Association Groups
14. Configuration Parameters
Technical Information
