HEATIZON.COM
25
15. FAQs
Q: What can I cut?
A:
The heating cable in the mat CANNOT BE CUT under any circumstances.
The mat (the white mesh strap) can be cut. The unconnected end of the cold lead
can be cut/shortened.
Q:
Can SnowMeltz® system be used for interior applications?
A:
No, but contact Heatizon to hear about one of our many other solutions
for interior applications.
Q:
Can SnowMeltz® system be used for roof/gutter heating?
A:
No, but contact Heatizon to hear about one of our many other solutions
for these scenarios.
Q:
Can SnowMeltz® be covered with gravel?
A:
No, the airflow around the gravel (no matter the size) will cause the SnowMeltz®
system to overheat and burnout.
Q:
Where should the activator/sensor be located?
A:
Arial or ground sensors must be located in or close to the area(s) to be heated, and
must
be able to detect moisture unabated. Temperature sensors (either separate or
combined) must be be able to read an accurate temperature for the area to be
heated.
Q:
Can multiple mats
be
controlled with one Activator?
A:
Yes
,
as long as the amp load for the activator is not exceeded or a relay/
contactor panel is used.
Q:
Are the 50 watt versions suitable for residential use?
A:
Yes, but normally are overkill and will result in higher electrical consumption. 37 watt
versions are suitable for most residential applications according to ASHRAE
standards.
Q:
Can 37 watt and 50 watt versions be mixed?
A:
No, keep similar watt mats together, do not mix 37 watt mats with 50 watt mats.
