24
DEW POINT
nOte:
As the temperature inside of the firebox is increasing, there will be some sweating inside the firebox.
There may be streams of water running down the inside firebox walls and down the inside of the firebox door.
Water may run out onto the fan cover, below the firebox door, out of the flue covers, and even out the ash pan.
the heatMOr™ is nOt LeaKinG!
Just as moisture collects on the inside of a
warm
house window on a
cold
outside day, the same thing is
occurring inside the HEATMOR firebox. The
warm
moisture in the exhaust is condensing on the
cold
firebox
walls of the HEATMOR. In most typical situations, once the water temperature is above approximately 130
degrees Fahrenheit, the sweating will stop because you are above the
dew point.
Loading Wood Pellets into the HEATMOR™
Please read through the entire HEATMOR™ Operation and Maintenance Manual and talk to your local dealer
for instruction.
Ask for a demonstration from your local dealer
.
it is very important to fully educate all
those who will be loading the furnace with wood pellets.
We suggest to set the Dayton auger speed control to 80 +/-5. Set the speed control to 80 then observe daily
ash removals for unburnt pellets. If there is some unburnt pellets in the ash pan then trying lowering the speed
control. If the furnace is not keeping up to your heatload, i.e. the unit is not getting up to temperature when
your house is calling for heat, try increasing the speed control. The optimum speed control setting will very
depending on what types of pellets you are using and the amount of heat being removed.
Here are some suggested points to assist you in loading pellets into your furnace.
1) Make sure you have your fuel readily available to fill your furnace. (ie. wood pellet bags
near
the
furnace and the tops cut open)
2) Maintain a clear, clean area in front and at the side of the furnace.
3) Open the small outer front door.
4) Open the internal hopper door.
5) Slowly pour the wood pellets into the internal hopper. The internal hopper can hold 4 - 40lb bags if it
is completely empty.
6) Pour pellets into the hopper until it is full and the hopper door can close securely without restriction.
7) Close the internal hopper door.
8) Close the small outer door and latch securely.
Summary of Contents for 200 SSP
