79
Burning wet wood or
poor quality wood.
Add dryer,
seasoned wood.
Refer to
“types of Wood.”
Opening door within
two minutes of blowers
turning off.
Open door sooner
or wait for next
cycle to start.
Refer to
“Loading Wood into the
heatMOr™.”
Firebox air leak.
Check all seals for
or air leaks.
Run a smoke check.
Refer to
“air Leaks.”
Flash Curtain / Heat
Shield has been
removed.
Install Flash
Curtain / Heat Shield
Refer to
“Flash curtain / heat shield.”
Water temperature is low.
Fuel fire.
Refer to
“Loading Wood into the
heatMOr™.”
Furnace pad has not
been raised above
ground level.
Raise pad.
Contact your
Local Dealer
.
Draft fan has not been
turned off while loading.
Turn off fan before
loading.
Refer to
“Loading Wood into the
heatMOr™.”
A.R.D. flipper is not
closing properly.
Refer to
“anti-rollout Device.”
Losing Water
Furnace is boiling (could
happen when away,
sleeping or at work).
Add water. Complete a
full furnace check of all
systems.
Refer to
“Filling the Furnace initially
with Water.”
Very slow leak
somewhere in the
system.
Check and tighten any
leaking fittings.
Contact your
Local Dealer
.
Someone is taking hot
water from the system
when needed.
Add water.
Refer to
“Water Level Maintenance.”
PrOBLeM
cause
sOLutiOn
PrOceDure
