HeatSeeker Swimming Pool Heat Pump: Page 9 of 10
K. Troubleshooting Your Swimming Pool Heat Pump: Parameter Settings
1. The heat pump has 11 control parameters from 00 to 10.
2. The parameters can be viewed but not changed while in operation mode. They can
only be changed in stand-by mode.
3. Use the SET button to scroll through the parameters.
4. If you need to change a parameter make sure the heat pump is in standby mode.
Parameter
Description
Range
Default Setting
Remarks
00
Setting of cooling temp
8 – 28°C
12°C
For technician only
01
Setting of heat temp
15 – 40°C
To be set by user
02
Defrosting period
30 – 90 min.
45 minutes
For technician only
03
Coil temp. start
defrosting
0 ~ -30°C
0°C
For technician only
04
Coil temp. stop
defrosting
2 – 30°C
13°C
For technician only
05
Defrosting time
1 – 12 min
8 minutes
For technician only
06
System number
1 – 2
1
May not be changed
07
Re-start after power
failure
0 / 1
1 = ja.
For technician only
08
Available Modes:
Cooling only= 0
H cooling = 1
Heating only= 3
0 – 3
3
For technician only
09
Work method.
0
0
May not be changed
10
Setting of water temp.
(auto mode )
30°C
30°C
For technician only
5. With the exception of Parameter 01 (setting the pool temperature set point) these
parameters are usually only changed by a service technician.
6. Most parameters can not immediately be changed, even in standby mode. If you are
sure you want to change a parameter proceed as below.
7. Before you change a parameter write down what it was set on.
8. In standby mode use the SET button to chose the parameter that needs changing.
9. Press the up and down arrows at the same time for about 5 seconds until you hear a
small bleep. This unlocks the parameter to enable setting.
10. Use the up and down arrow to set the parameter to the new desired level.
11. After a few seconds the panel will revert to the standby mode with the new setting
stored.
12. If you need to check the parameter setting use the SET button to display that
parameter.
L. Accessories
The heat pump has a housing and cover plate to allow the digital control panel it to be
mounted remotely if required. A 5m extension line with socket for this purpose is provided
with the kit.
