8
Figure 5 Clearances around the heater before use
How to fill the tank
Make sure the power plug is removed from the
power source and the power switch is in OFF
position “0”.
Place the appliance on stable and level ground,
remove the fuel cap and fill the fuel tank – see
figure 4. DO NOT overfill with diesel or
kerosene. Only refill when the fuel filter is
installed. After filling turn the cap clockwise and
tighten it.
Safety clearances
Figure 4 Filling the tank
Operation/Ignition
Check the fuel tank and ensure there is sufficient fuel in it.
DO NOT
stand or place any object less than 3m from the heater output and
keep the heater a minimum of 2m from any walls or objects (see figure 5
above).
Insert the plug in the socket.
Put the
POWER
switch to position “
1
” the indicator lights up.
Press the
IGNITION
button, the motor begins to run and the spark plug
ignites.
Stop using the appliance if there is smoke or a strange odour omitted.
Make sure the heater is ignited.
ATTENTION!
while the heater is operating, never allow the floor surface to
overheat.
HSFAH30_instructions 13/7/15 12:55 Page 8
