Thermostat
Turn the thermostat to maximum position.
When the temperature rises to a comfortable level, slowly turn thermostat
counter-clockwise until the power indicator light just goes out. The room
temperature will now be kept constant.
When the temperature is below the thermostat value, the heating element will
switch on and the neon indicator will light (or both indicators if maximum
power was set).
To turn off the heater, set the power switch to “
0
” position. The power indicator
light turns off. Unplug the product from the electrical outlet when it is left
unattended or is not in use.
Timer operation
This appliance has a built in timer –
Figure 8
– which is operated in the
manner shown below.
Each segment is 15 minutes, push a
segment in towards the centre to turn the
radiator OFF and push a segment
outwards to turn the radiator ON. To set
the time, prior to programming the
ON/OFF setting:rotate the timer
clockwise until the arrow marker points
to the correct time.
Safety Control (Thermal Cut-Out)
This product has an overheat protection
system, which turns the appliance off if it
becomes excessively hot. If this should
happen to the product ensure that the
appliance is turned to the off position “
O
”, unplug it from the mains power
supply and allow to cool.
If this problem persists please contact Heatstore.
Safety Control (Tip over switch)
This product has a tip over safety switch which will stop the appliance from
working if it is knocked over or installed upside down. The product will only work
when it is in an upright position.
5
Figure 8
HSOFR_TXinstructions 26/11/15 11:37 Page 5
