background image

HSXCA(X) 

MODELS:

HSXCA12X 1.7KW/12kWh Storage and 1kW Convector
HSXCA18X 2.5kW/18kWh Storage and 1.5kW Convector
HSXCA24X 3.4kW/24kWh Storage and 2kW Convector

INSTALLATION AND OPERATING

INSTRUCTIONS

IMPORTANT

PLEASE READ THIS LEAFLET CAREFULLY AND RETAIN FOR FURTHER 

USE.  NOTE ALSO THE INFORMATION GIVEN ON THE HEATER

 

The installation must be carried out by a trained competent personnel.

 

A means for disconnection must be incorporated in the 

fi

 xed wiring by a double pole switch with a contact separa-

tion of a minimum of 3mm and in accordance with the current IEE Wiring Regulations

 

The heater must not be installed immediately below a 

fi

 xed socket outlet.

 

The heater is not suitable for connection to a 30A ring circuit (24 hour peak supply).

 

Do not position the heater under windows where curtains can contact the heater casing.

 

WARNING - THE SURFACES ON THIS HEATER CAN BE HOT

 

This heater meets EN60335 safety requirements. However, any heater type becomes  hot in normal operation. 
Care must be taken to ensure that prolonged skin contact with the heater does not occur.

     WHERE YOUNG CHILDREN, INFIRM PERSONS, OR THE AGED ARE PRESENT THIS APPLIANCE MUST 

BE ADEQUATELY GUARDED. Contact your installer or manufacturer for further advice.

  This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental 

capabilities, or lack of experience and knowledge, unless they have been given supervision for instruction concerning 
use of the appliance by a person responsible for their safety.  Children should be supervised to ensure that they 
do not play with the appliance.

 

This appliance is very heavy and must be securely 

fi

 xed to a wall. DO NOT UNDER ANY CIRCUMSTANCES 

ATTEMPT TO MOVE OR REPOSITION THIS HEATER WITHOUT SEEKING EXPERT ADVICE.

  To maintain stability, it is essential that the heater is placed on a level surface.

 

This heater must be installed where it is impossible for switches and other controls to be touched by a person 
using a bath or shower.

 

IMPORTANT - Due to the newness of materials the heater will produce a slight smell for the 

fi

 rst few days of 

operation.  ROOMS MUST BE WELL VENTILATED AND YOUNG CHILDREN, CAGED BIRDS, OR PERSONS 
WITH RESPIRATORY COMPLAINTS MUST NOT  REMAIN IN CLOSE PROXIMITY TO THE HEATER DURING 
THE FIRST 48 HOURS OF THE COMMISSIONING PERIOD.

 

IF, DURING ANY REASSEMBLY OF THE HEATER, A PART OF THE THERMAL INSULATION SHOWS DAMAGE 
OR DETERIORATION WHICH MAY IMPAIR SAFETY, IT SHOULD BE REPLACED BY AN IDENTICAL PART.

COMBINED STORAGE AND 
CONVECTOR HEATER

88962

Summary of Contents for HSXCA12X

Page 1: ...LY GUARDED Contact your installer or manufacturer for further advice This appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision for instruction concerning use of the appliance by a person responsible for their safety Children should be supervised to ensure that...

Page 2: ...he floor 3 4 Mark the position of the two outside corners of the wall bracket with the heater pushed tight against the wall Remove the bracket from the heater by removing the screw at each end Place the heater to one side and reposition the bracket against the wall using corner marks for alignment Four fixing positions must be chosen for the 24 three for the 18 and two for the 12 Mark the position...

Page 3: ...the two screws in the block 12 Fit the front layer of bricks again with the recess towards the element The complete core will comprise 12 2 x 4 Brick Columns 18 3 x 4 Brick Columns 24 4 x 4 Brick Columns 13 Replace the inner front complete with insulation by locating its bottom edge behind the front lip of the chas sis and inserting retaining screws along the top and both sides 14 Check that the f...

Page 4: ...evel at which the room temperature will be controlled Your comfort level can easily be established by gradually adjusting the thermostat until the required room temperature is maintained To maintain the appearance of the heater wipe occasionally with a dry cloth when the heater is cool Do not use abrasive powders or furniture polish Discoloration of wall finishes can sometimes occur immediately ab...

Reviews: