HEC HEC12EFM Series, Instructions For Use Manual

15

Washing dishes

Programme selection

The most appropriate programme can be identified by comparing the type of crockery, cutlery, etc., as

well as the amount and condition of food remains, with the details contained in the wash cycle table.The

corresponding programme sequence, duration and consumption details are shown in the right half of the

overview. For example:

Use the “Normal Wash”        programme for dishes and utensils which have plenty of food remains stuck

on hard.

Earn savings

If only a small number of dishes have been loaded into the dishwasher,selecting a programme that

operates at the next lowest temperature will usually be sufficient.

Programme data

The stated programme data are based on standard operating conditions. The values can vary consider-

ably according to:

different amounts of dishes

temperature of mains water supply

pressure of mains water supply

ambient temperature

fluctuations in mains voltage

machine-related factors (e.g. temperature, water volume,...)

Turning  on the Appliance

Starting a wash cycle...

Make sure that the plug for the appliance is inserted into the wall socket.

Make sure that the water supply is turned on to full pressure.

Load the dishwasher .

Pour in the detergent.

Press the “ON-OFF” button, and the “ON-OFF” light will turn on.

Turn the knob located on the right of the control panel until the number or symbol for the cycle setting

is aligued with the refrence mark (see the section entitled, program overview). If the knob rightly

aligned with the refrence mark you want to choose, you must turn the knob to with the mark of

“Reset” .Then back to first step.

After five seconds the “ON-OFF” light will turn off, the wash cycle will begin.

en