HEC HEC12EFM Series, Instructions For Use Manual

Safety information

2

At time of delivery

Check packaging and dishwasher immediately for signs of transport damage. If the appliance is

damaged, do not put it into use but contact your supplier or customer service without delay.

Please dispose of packaging materials properly.

The dishwasher must only be used by adults for the washing of  household dishes and cooking utensils.

This appliance cannot be installed outdoor, not even if the area in which it is installed is covered by a

roof; it is also very  dangerous to leave it exposed to the rain and elements.

Do not place any heavy objects or stand on the door when it is open. The appliance could tip forward.

The water inside the dishwasher is not suitable for drinking.

Do not use solvents of any kind inside your dishwasher. They could cause an explosion danger.

Open the door very carefully if the dishwasher is operating. There is a risk of water squirting out.

During normal use

Do not touch the heating element during or after a wash cycle.

Fundamental rules to follow when using the appliance:

-  Never touch the dishwasher when barefoot or with wet hands or feet;

-  We discourage the use of extension cords and multiple  sockets;

-  If the appliance is not operating properly or maintenance must be performed, disconnect the

   appliance from the power supply.

Site the dishwasher and connect it up in accordance with the installation instructions.

The dishwasher must not be connected to the electricity supply while installation is being carried out.

Ensure that the domestic wiring is properly earthed.

The mains electricity supply must conform to the details shown on the dishwasher nameplate.

Do not connect the dishwasher to the electricity supply via an extension cable.

Built-under and built-in appliances should always be installed under a continuous work surface which

is attached to the adjacent cupboards, in order to ensure that the appliance is entirely stable.

After the appliance has been installed,the mains plug should still be easily  accessible.

The plastic housing on the water inlet contains an electrically operated valve.The connecting wires are

inside the inlet hose.Do not cut through this hose and do not immerse the plastic housing in water.

During installation, the power supply cord must not be excessively or dangerously bent or flattened.

During installation

en