PURPOSE OF THE MACHINE
The machine is intended for cleaning of air-driven spray-guns that have been used for painting with water-based paint
systems.
The unit has two separate areas for cleaning:
1. An automatic washer (item 1 illustration 1), intended for cleaning of spray-guns with gravity fed paint-cups.
In this washer water or water-based solvents can be used.
2. A sink (item 2 illustration 1), intended for manual cleaning of other tools used in connection with vehicle paint-
jobs like: spray-guns with suction fed paint-cups, filler scrapers, paint brushes and such.
In this sink water only shall be used.
All other use of the unit are not allowed like:
Emptying excess paint into the unit
Cleaning of electric chargeable items
Collecting of various waste
Cleaning of textile materials
Storing of items
Cleaning of hands or other parts of the human body
Cleaning of any items for food or drinks
The coagulation process described below (according to recommendations from the paint manufacturer) allows the
cleaning water to be re-used. CHECK CAREFULLY WITH THE APPROPRIATE AUTHORITY TO ENSURE THAT THE
FILTERED WATER OBTAINED AFTER THE COAGULATION PROCESS MAY BE EMPTIED INTO THE REGULAR
DRAIN-WATER SYSTEM. YOU MAY NEED INFORMATION FROM THE PAINT MANUFACTURER WHEN DOING SO
ASSEMBLY
First of all, check if the machine has been damaged during the transport. Remove the packaging and check
again that the machine has not been damaged during the transport. If so, report this immediately to the transport
company.
Fit the air-driven extractor (item 3 illustration 1) over the flange of the automatic washer, and connect it to the
blue air-hose (taped on the backside of the unit) by sticking the hose into the connector of the extractor.
The air-line on the left side of the unit (item 4 illustration 1) is during transport placed inside the unit. Take it out,
and fasten it with the magnet in a suitable place on the left side. This air-line is intended to blow out the spray-gun after
the cleaning procedure.
The air-gun on the right side of the unit (item 12 illustration 1) is during transport placed inside the unit. Take it
out, and fasten it with the magnet in a suitable place on the right side. This air-gun is intended to blow the spray-gun
dry after the cleaning procedure.