Hedson DRESTER Compact DC12, Original Operator'S Manual

INSTR:  17625                           REV: ECO-10003    2014-11-06 / TB                   GODK:                                    SID: Sida 7 / 37 

SAFETY INFORMATION 

Hazards may arise from improper use of the DRESTER Compact DC12. Hazards may also arise from improper choice/handling of 
drums or solvent. In order to maintain the high safety standard of the unit, it is important that these instructions are followed. 

-

Do not operate the unit until you have read and fully understood this entire User’s Manual. 

-

The unit should be isntalled as described in the instructions. 

-

The unit should be used as described in the instructions. 

-

The unit should be maintained as described in the instructions. 

-

Only original spare parts may be used. 

-

This User’s Manual must be available and in legible condition in close proximity to the unit. Every user shall know where 
to find the User’s Manual. 

-

Operating instructions should be formulated on the basis of this Users Manual, and translated into the language spoken by 
the employees.  

-

Do not modify or in any way alter the unit. 

-

Do not operate the unit unless it is properly vented. Do not operate the unit if the extraction of vapors is insufficient. 

-

Avoid contact with liquid and vapor. Refer to the solvents’ MSDS (Material Safety Data Sheet). 

-

Wear chemical goggles or similar, to protect your eyes. Wear chemical-resistant gloves to prevent skin-contact. Wear 
chemical-resistant clothing to protect against spills or splash. 

-

Personnel suffering from respiratory problems or allergies to solvents used, must not operate the machine.  

-

Clean up spills immediately. Solvent vapours are heavier than air and can spread a long way. They may also collect in pits 
or other low areas. 

-

Do not smoke, eat or drink while close to the unit. 

-

The unit is equipped with a safety valve that will interrupt the automatic wash cycle if the lid is opened before the wash 
cycle is completed. 

-

A fire extinguisher must always be kept nearby when working with flammable solvents. Do not use water. 

-

 Spray guns or any other paint equipment items cleaned in the unit must be suitable for cleaning in a Zone 1 area (ref. 
Category 2 according to EN 13463-1/2001). If unsure, please contact the spray gun manufacturer. 

-

The unit must be properly grounded using the attached grounding cable. If plastic drums are used, the openings should be 
wiped off with a damp cloth, to avoid static electricity, before inserting or removing any hoses or other equipment. 

TECHNICAL DATA 

 
Manufacturer     

HEDSON TECHNOLOGIES AB 

Hammarvägen 4 

SE-232 37 Arlöv 

Sweden 

Tel.: +46-40- 53 42 00 

 
Type of machine: 

DRESTER Compact DC12 

Permitted solvents:  

See section “Permitted Solvents” 

Max solvent volume of machine: 

15 + 15 litres  

(Check for local regulations concerning max allowed volume for keeping solvent in the unit) 
Maximum drum size: 

30 litres 

Compressed air needed: 

7-12 bar (110-180 psi), 300 litres/min (11 cfm) 

Extraction capacity: 

360 m

3

/hour (225 cfm) (with a 5 m extension)  

330 

m

3

/hour (206 cfm) (with a 15 m extension) 

Pump capacity:   

10 l/min   

Solvent pressure 

2 bar (30 psi) 

Weight 

30 kg (66 lb) 

Overall dimensions:  

Height: 1340 mm (53”) width (without drums): 570 mm (22,5”)  
Depth (lid closed): 440 mm (17,5”) 
Depth (lid opened): 590 mm (23”) 

Extractor diameter: 

80 mm (3 3/16”) 

Sound pressure level:  

<70 dB(A)