10
General Use
Operating the H95
The source and volume can be changed
using the volume and input selector on the
front panel or using the remote control.
The volume level is indicated by a number
between 0 and 99, with 0 being mute level
and 99 being max volume. The H95 powers
up at a default volume 20. This value can be
changed, see Special Functions.
Power Button
The H95 amplifier is switched on and off
with the power button located on the under-
side of the amplifier, towards the front of
the unit. When powered up, the H95 takes
a few seconds to calibrate. During this time,
the outputs are muted.
NOTE: When powering up, the outputs are
muted and the volume flashes to indicate
that mute is on. This is normal, and is part
of the start-up procedure.
NOTE: When the H95 has been switched off,
wait 30 seconds before powering it on again.
Headphone Output
Connect the 6.3mm headphone jack to
the front of the H95. This activates the
headphone volume control and mutes the
speaker outputs.
NOTE: Variable Line Output is still active.
Mute
Pressing the mute button on the Hegel
remote control mutes the outputs on the
amplifier. The volume flashes to
indicate that mute is on. Press the mute
button, or adjust the volume level, to switch
mute off.
Status Indicators
The Hegel H95 will display the network status
in the lower left corner.
Network status is OK:
Network status is
not
OK:
