Technical Data and Accessories
Nexscan F 4100/F 4200 – Operation
7–11
ABC
Al Si9 Cu3 is used as cast aluminum, galvanized
X42 is favourable for the steel plate. The glass
panes are made of float glass, they are partially
printed and hardened, the mirrors fitted to some
types of device are made of aluminized float glass.
Dismantling
The following order is recommended for
dismantling. Observe the figures at the end of this
section.
The device may only be dismantled by a
recognized waste disposal company; these
dismantling instructions do not apply for the
customer!
Work step
Note
1. Remove the glass plate from the lid.
2. Open the transparencies lighting in
the lid, remove two fluorescent lamps.
3. Detach the lid
4 items 6 socket screws on the
lower rails, 2 hexagon socket
screws on the upper rails
4. Unscrew the fluorescent lamp
ballasts in the lid from the rear
5. Detach original glass plate from main
device
6. Remove the cover flap from the main
device
The cover flap is only inserted, it
is not screwed in place. The lid
must be detached (see step 4) in
order to remove the flap and
thus access the interior of the
device.
