Commissioning | Configuring the axes
7
Tap
Axes
Tap the axis name or
Not defined
, if applicable
If applicable, select the axis name for the axis in the
Axis
name
drop-down list
Tap
Encoder
Select the connection for the corresponding encoder from
the
Encoder input
drop-down list:
X1
X2
X3
The available encoder information is transmitted to the
product
The settings are updated
Select the encoder model from the
Encoder model
drop-
down list:
Linear encoder
Angle encoder
Angle encoder as linear encoder
If you selected
Angle encoder as linear encoder
, then enter
the
Mechanical ratio
If you selected
Angle encoder
, specify the
Display mode
Tap
Reference point displacement
Use the
ON/OFF
slide switch to activate or deactivate
Reference point displacement
(calculation of the offset
between the reference mark and the machine zero point)
If activated, enter the offset value for
Reference point
displacement
Confirm the entry with
RET
or
To apply the current position as the offset value, tap
Apply
under
Current position for reference point shift
To switch to the previous display, tap
Back
To view the electronic ID label of the encoder, tap
ID label
In order to see the results of the encoder diagnosis, tap
Diagnosis
"<Axis name> (settings of the axis)", Page 196
88
HEIDENHAIN | GAGE-CHEK 2000 | Operating Instructions | 08/2020
Summary of Contents for GAGE-CHEK 2000 Series
