Settings |
Axes
11
11.6.13
Create table of supporting points
Path:
Settings
►
Axes
►
<Axis name>
►
Error compensation
►
Segmented linear error compensation (SLEC)
►
Create table of supporting points
Parameters
Explanation
Number of supporting points
Number of supporting points on the mechanical axis of the
machine
Setting range:
2 ... 200
Default value:
2
Spacing of the supporting points
Spacing of the supporting points on the mechanical axis of the
machine
Default value:
100.00000
Start point
The start point defines the position starting from which the
compensation is applied to the axis
Default value:
0.00000
Create
Creates a new table of supporting points based on the entries
204
HEIDENHAIN | GAGE-CHEK 2000 | Operating Instructions | 08/2020
Summary of Contents for GAGE-CHEK 2000 Series
