Commissioning | Steps for commissioning
Configuring the axes
For EnDat interfaces:
compensation
Ascertaining the line count
For 1 V
PP
or 11
μ
A
PP
inter-
faces:
mark search
Configuring the axes for
compensation
Ascertaining the line count
For TTL interface:
encoders with TTL interface
Performing error
compensation
Ascertaining the output
OEM area
Adding documentation
Adding a startup screen
Configuring the unit for screenshots
Backing up data
Back up settings
Back up user files
NOTICE
Loss of or damage to configuration data!
If the product is disconnected from the power source while it is on, the
configuration data can be lost or corrupted.
Back up the configuration data and keep the backup for recovery purposes
7.4
Basic settings
7.4.1
Activating the
Software options
Additional
Software options
can be enabled on the product via a
License key
.
You can view the enabled
Software options
on the overview page.
"Checking the Software options", Page 81
Requesting license key
You can request a license key by using the following procedure:
Reading out device information for the license key request
Creating a license key request
7
HEIDENHAIN | GAGE-CHEK 2000 | Operating Instructions | 08/2020
79
Summary of Contents for GAGE-CHEK 2000 Series
