en
HEIDENHAIN | QUADRA-CHEK 3000 | Installation Instructions | 4/2016
23
4
Mounting
4.1
Overview
This chapter contains all the information necessary for
mounting the product.
The following steps are only to be performed
by qualified personnel.
4.2
Assembly of the device
General mounting information
The receptacle for the mounting variants is provided on
the rear panel. The connection is compatible with VESA
standard 100 mm x 100 mm.
The material for attachment of the mounting variants on
the device is included in delivery.
You will also need the following:
Torx T20 screwdriver
Torx T25 screwdriver
Hex key, width A/F 2.5 (Duo-Pos stand)
Material for mounting on supporting surface
The product must be mounted on a stand
or holder to ensure the correct and intended
operation of the product.
4.2.1
Mounting on Duo-Pos stand
You can attach the Duo-Pos stand to the product at a 20°
or 45° angle.
Use the two supplied M4 x 8 ISO 7380 hexagon socket
screws to attach the stand to the lower threaded holes
on the rear panel. The permissible tightening torque is
2.5 Nm.
Using the mounting slots (width = 4.5 mm), you can
screw the stand to a supporting surface.
The cables are routed together through the two supports
of the stand from behind and then through the lateral
openings to the connections.
Dimensions of the Duo-Pos stand
Further information:
4.2.2
Mounting on Multi-Pos stand
Use the four supplied M4 x 8 ISO 14581 (black)
countersunk screws for attachment to the threaded holes
on the rear panel. The permissible tightening torque is
2.5 Nm.
Using two M5 screws, you can screw the stand to a
supporting surface from the bottom.
You can tilt the stand to any angle within the 90° tilt range.
The recommended tightening torque for the T25 screw is
5.0 Nm. The maximum permissible tightening torque
for the T25 screw is 15.0 Nm.
The cables are routed together through the opening in the
stand from behind and then laterally below the joint to the
connections.
Dimensions of the Multi-Pos stand
Further information:
4.2.3
Mounting on Multi-Pos holder
Use the four supplied M4 x 8 ISO 14581 (black)
countersunk screws for attachment to the threaded holes
on the rear panel. The permissible tightening torque is
2.5 Nm.
You can tilt the holder to any angle within the 90°
tilt range. The recommended tightening torque for
the T25 screw is 5.0 Nm. The maximum permissible
tightening torque for the T25 screw is 15.0 Nm.
The cables are routed together through the opening in the
holder from behind and then laterally to the connections.
Dimensions of the Multi-Pos holder
Further information:
