LEVELLING THE WASHER DRYER
WARNING! The lock nuts on all four feet must be screwed tightly against the housing.
1. Check if the legs are closely attached to the cabinet. If not, please turn them to
their original positions tighten the nuts.
2. Loosen the lock nut turn the feet until it closely contacts with the floor.
3. Adjust the legs and lock them with a spanner, make sure the machine is steady.
CONNECT WATER SUPPLY HOSE
WARNING!
•
To prevent leakage or water damage, follow the instructions in this chapter!
•
Do not kink, crush, modify or sever water inlet hose.
•
For models equipped with hot valve, connect it to hot water tap with hot water supply
hose. Energy consumption will decrease automatically for some program.
Connect the inlet pipe as indicated. There are two ways to connect the inlet pipe.
2.
Connection between ordinary tap and inlet hose.
2 Connection between screw tap and inlet hose.
Raise
Lower
Lock nut
foot
Loosen clamp nut
and four bolts
Tighten clamp nut
Press slide bushing,
insert inlet hose into
connecting base
Connecting
finished
Tap with threads and inlet hose
Special tap for washer dryer
clamp nut
slide bushing
slide bushing
Summary of Contents for HWDM-8614B
