www.heinner.com 9/6kg, 220-240V~50Hz, 1400rpm
10
NOTE:
Operating your machine under low voltage will cause the life cycle of your machine
to be reduced and its performance to be restricted.
4.
Water Inlet Connection
•
Connect your Washer Dryer to your cold water supply only.
•
Only use the water inlet hose supplied with your machine or one purchased
through an authorised dealer.
•
A gasket is included in the hose packaging to prevent water leaks from
connections. Fit this gasket to the end of the water inlet hose that will be
connected to the tap.
•
Connect the angled end of the water inlet hose to the cold water inlet on the
rear of the machine and hand-tighten.
•
Screw the other end of the water inlet
hose onto a 3/4” water tap and hand
-
tighten.
•
If in any doubt, consult a qualified plumber.
•
Turn the cold water supply on and check for any leaks.
•
Water flow with pressure of 0.1-1 Mpa will allow your machine to operate at
optimum efficiency (pressure of 0.1 Mpa means that more than 8 litres of
water per minute will flow through a fully opened tap).
•
Ensure that the the hose is not trapped, kinked, twisted, folded or crushed.
5.
Water Draining Connection
NOTE
: Use only the new water inlet hose coming with your machine while making water
inlet connections of your machine. Never use old, used or damaged water inlet hoses
.
•
Connect the water drain hose to a standpipe or to the outlet elbow of a
household sink, using additional equipment. The hose must be placed
between 0 cm and 80 cm from the ground.
•
Never attempt to extend the water drain hose.
Summary of Contents for HWDM-V9614D
