ROTARY HAMMER
4.
Wear a hard hat (safety helmet), safety glasses and/or face shield. Ordinary eye or sun
glasses are NOT safety glasses. It is also highly recommended that you wear a dust mask
and thickly padded gloves.
5.
Be sure the bit is secured in place before operation.
6.
Under normal operation, the tool is designed to produce vibration. The screws can come
loose easily, causing a breakdown or accident. Check tightness of screws carefully before
operation.
7.
In cold weather or when the tool has not been used for a long time, let the tool warm up
for a while by operating it under no load. This will loosen up the lubrication. Without
proper warm-up, hammering operation is difficult.
8.
Always be sure you have a firm footing. Be sure no one is below when using the tool in
high locations.
9.
Hold the tool firmly with both hands.
10.
Keep hands away from moving parts.
11.
Do not leave the tool running. Operate the tool only when hand-held.
12.
Do not point the tool at any one in the area when operating. The bit could fly out and
injure someone seriously.
13.
Do not touch the bit or parts close to the bit immediately after operation; they may be
extremely hot and could burn your skin.
14.
Some material contains chemicals which may be toxic. Take caution to prevent dust
inhalation and skin contact. Follow material supplier safety data.
SAVE THESE INSTRUCTIONS
WARNING:
MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious
personal injury.
