ROTARY HAMMER
Drilling
For drilling in wood, metal or plastic materials, depress the release button
3
and rotate the mode
selector switch
4
so that the pointer points to the symbol
. Rotate the mode selector switch
5
so that it points to the symbol . Use a twist drill bit or wood bit.
WARNING:
The following combination cannot output any function.
ASSEMBLY
WARNING:
•
Always be sure that the tool is switched off and unplugged before carrying out any work
on the tool.
Auxiliary handle
WARNING:
•
Always use the auxiliary handle to ensure operating safety when drilling in concrete,
masonry, etc.
•
When the bit begins to break through concrete or if the bit strikes reinforcing rods
embedded in concrete, the tool may react dangerously. Maintain good balance and safe
footing while holding the tool firmly with both hands to prevent dangerous reaction.
The auxiliary handle swings around to either side, allowing easy handling of the tool in any
position. Loosen the auxiliary handle
7
by turning it counterclockwise, swing it to the desired
position and then tighten it by turning clockwise.
Fig. 4
Fig. 5