ROTARY HAMMER
Depth gauge (see figure 6)
The depth gauge
9
is convenient for drilling holes of uniform depth. Insert the depth gauge into
the hole in the grip base. Adjust the depth gauge to the desired depth and then tighten the
clamp screw
8
to secure the depth gauge.
Note:
The depth gauge cannot be used at the position where the
depth gauge strikes against the tool body.
Bit grease
Coat the bit shank head beforehand with a small amount of bit grease (about 0.5 -1 g; 0.02 -
0.04 oz.). This chuck lubrication assures smooth action and longer service life
Changing the bit
Before any work on the tool itself, pull the mains plug.
With the SDS-plus tool holder, simpler and easier tool changing is possible without additional
aides.
The dust cap
1
largely prevents the entry of drilling dust into the tool holder during operation.
When inserting the tool, take care that the dust cap
1
is not damaged.
A damaged dust protection cap should be changed immediately.
We recommend having this
carried out by an after-sales service.
Inserting the bit (see figure 7)
Clean and lightly grease the shank end of the tool.
Push back the locking sleeve
2
and Insert the bit in a twisting manner into the tool holder until
it locks itself.
After installing, always make sure that the bit is securely held in place by trying to pull it out.
Removing the bit (see figure 8
）
Push back the locking sleeve
2
all the way and pull the bit out.
Fig. 6
Tighten
Loosen
Fig. 7
Fig. 8
