12
GASOLINE CHAIN SAW
STOPPING ENGINE
1. Release the throttle lever to allow the engine idling for a few minutes
2. Put the switch to the “O”(stop) Position. (F18)
(1) Switch
8. SAWING
WARNING
Before proceeding to your job, read “For Safe Operation” section it is recommended to
first practice
sawing easy logs. This also helps you get accustomed to your unit.
Always follow the safety regulations. The chain saw must only be used for cutting wood. It is forbidden to
cut other types of material. Vibrations and kickback vary with different materials and the requirements of
the safety regulations would not be respected. Do not use the chain saw as a lever for lifting, moving or
splitting objects. Do not lock it over fixed stands. It is forbidden to hitch tools or applications to the p.t.o.
that are not specified by the manufacturer.
It is not necessary to force the saw into the cut. Apply only light pressure while running the engine at full
throttle.
When the saw chain is caught in the cut, do not attempt to pull it out by force, but use a wedge or a lever
to open the way.
GUARD AGAINST KICKBACK (F19)
This saw is equipped with a chain brake that will stop the chain in the event of kickback
if operating properly. You must check the chain brake operation before each usage by
running the saw at full the throttle for 1-2 seconds and pushing the front hand guard
forward.
The chain should stop immediately with the engine at full speed. If the chain is slow
to stop or does not stop. replace the brake hand and clutch drum before use.
It is extremely important that the chain brake be checked for proper operation before
each use and that the chain be sharp in order to maintain the kickback safely lever of this saw. Removal
of the safety devices. Inadequate maintenance. or incorrect replacement of the bar or chain may increase
the risk of serious personal injury due to kickback.
FELLING A TREE (F20)
1. Decide the felling direction considering the wind, lean of the tree, location of heavy
branches, ease of job after felling and other factors.
2. While cleaning the area around the tree, arrange a good foothold and retreat path.
3. Make a notch cut one-third of the way into the tree on the felling side.
4. Make a felling cut from the opposite side of the notch and at a level slightly higher
than the bottom of the notch.
