4 Setpoint
Positioner DC 6-06
15
3
Parameterization of the HEINZMANN control units
The following chapters describe the functions of the
HEINZMANN
control units and how
they are set. Some functions only act together with others, or are influenced by other
functions. When functions like these are parameterized and optimized, it is often advisable to
deactivate other functions so that only the effect of the required function is seen. The setting
of these functions is described in the individual chapters.
3.1
Parameterization options
There are a number ways in which
HEINZMANN
control units can be parameterized. For
experimental work and first commissioning HEINZMANN recommends the use of
as a diagnostic and parameterization tool. DcDesk 2000 can also be used for
service purposes, although the hand programmer units PG 02 and HP 03 are also available.
The DcDesk 2000/Saturn remote communication option also provides considerable
assistance for servicing.
The following list gives an overview of all the parameterization options that are available.
Parameterization by HEINZMANN
Control unit operation is tested with a test routine during final inspection at the factory.
Parameterization with the hand programmer
Complete parameterization can be carried out with the hand programmer PG 02 or
HP 03 depending on the level. This handy device is suitable for use mainly by service
personnel.
Parameterization with DcDesk 2000 or DcDesk 2000/Saturn
Depending on the level, a number of parameters can be continuously displayed and
edited with a DcDesk 2000 PC program. The PC program also allows the graphic
display and simple setting of curves. Control unit data can be stored on the PC or
uploaded from the PC back to the control unit. Another advantage of the PC program is
the high resolution visualisation of measured values against time or against one
another.
Transferring records
Once the parameterization for an application has been finalised, the data record can be
stored in the hand programmer or on the PC. If there are other applications of the same
type, these data records can be transferred to the new control units.
End-of-line parameterization
This option is used for test bench runs by the system manufacturer. The control unit is
adapted to the requirements specified in the order. Both the control unit firmware and a
delivery data record can be programmed during the end-of-line run with a command
line call from the DcDesk 2000; operator action is not required.
Summary of Contents for PANDAROS DC 6-06
Page 2: ......
