12
INTENDED USE
•
Device is not approved for commercial/industrial use. Use exclusively in private households.
•
Do not use device to suck up flammable liquids, ash, paint, lacquer, or other chemicals.
•
Device not suitable for continuous operation such as pond or cistern emptying.
�
SAFETY NOTES
�
Any use of the device not described in these instructions is not permitted.
�
Only use approved extension cables.
�
Before every use, check the correct fitting of the motor head and all other components required
for operation, particularly the filter sponge.
�
Do not pull or lift the device by the connecting cable.
�
The device may not be operated in the event of a faulty lead or mains plug.
�
Do not immerse device in water or spray with water. Do not use device in the rain.
�
Do not operate the device unattended.
�
During use as a pond vacuum cleaner or as a pool cleaner, operate device a sufficient safety
distance of 2 m from the pond.
�
Only operate the device on a suitable, stable, even base.
�
If the motor head or connecting cable are wet, do not operate device, or immediately disconnect
from the mains.
�
Check the position and presence of the filter sponge before every use.
�
Do not direct the suction hose towards people or parts of the body.
�
Disconnect from the mains before emptying the container manually.
DESCRIPTION AND ASSEMBLY
A
Motor head
B
On/off switch
C
Drain hose
D
Debris collection bag
F
Sealing cap
G
Closing clip motor head
H
Connector suction hose
I
Container
L
Suction hose
M
Suction pipe 4 pieces
O
Suction nozzle
P
Pump
Q
Handle with airflow gate
R
Filter sponge
S
Check valve
DESCRIPTION OF FUNCTION
The device extracts mud from bodies of water through the suction hose attached to the connector. The
suction performance can be regulated using the valve on the suction hose handle. The debris collection
bag in the device container collects coarse dirt particles and thus prevents the drainage pump from
becoming blocked. If suction performance is diminished, the debris collection bag must be cleaned.
The drainage pump pumps the waste water from the container via the drain hose. The float in the filter
support basket protects the suction head by preventing water from entering it. The filter foam must
be cleaned regularly to ensure faultless functioning. The float must be able to move freely. Protective
function of the float: If the waste water level in the container increases excessively, the float closes the
suction opening in the suction head and switches the suction head off. At the same time, the operating
noise changes noticeably. Switch the device off, disconnect it from the power supply and remove the
blockage in the drainage pump.
The following restrictions apply to the device:
�
Never operate without a flow of water.
�
The proportion of water in the debris must be at least 20%.
�
Only operate with water at a water temperature of +4 °C … +35 °C.
�
Never use liquids other than water.
�
Do not use as a dry vacuum cleaner.
�
Do not use in conjunction with chemicals, foods, highly combustible or explosive substances.
�
Do not transport when filled.
ASSEMBLY AND START-UP
Before every use, fit the filter sponge
R
via the float cage to prevent water or dust from penetrat-
ing into the motor head
A
. Check the presence of the filter sponge before every use. Immediately
replace the filter sponge if faulty. Allow the filter sponge to dry before using the device again.
1
EN
F650P Betriebsanleitung-Garantie.indd 12
28.09.2017 10:19
