14
Downloading the Video & Pictures from the Camera
Install the MicroSD card into the reader.
Plug the reader into the USB port of
your computer.
The USB connection will be auto
recognized and the files ready to be
transferred.
At this point you can copy or transfer
your files to your folder structure.
®
SYSTEM ADJUSTMENTS
SYSTEM ADJUSTMENTS
NOTE:
The TX465 is set up from the factory. However, if you ever need to
make changes or calibrate the gyros, see the instructions below.
To enter the calibration mode, press and hold down on the right stick.
While holding the right stick down, press down on the left stick 4 times.
Release both stick assemblies. To exit the calibration mode, press down
on the left stick.
Control Board Sensor Calibration:
Press up on the throttle trim button
to calibrate the control board sensors. The Status LED should fl ash rapidly
for about a minute. When it stops fl ashing, the calibration procedure is
completed.
Return to Pilot Speed:
To adjust the speed that the 230Si returns to the
pilot, use the rudder trim button. Pushing the button to the left will make
the quadcopter return faster. Pushing the button to the right will make
the quadcopter return at a slower speed.
Trim Adjustments:
If the 230Si is always drifting off in the same direction,
hover the quadcopter to determine the direction and speed of the drift.
A drift forward or backward will be controlled by moving the fore/aft trim
button next to the right stick in the opposite direction. A drift left or right
will be controlled by moving the left/right trim button below the right stick
in the opposite direction.
