MCX3V5 Camera Gimbal
Page 5
Please connect the servo to receiver AIL Channel (Futaba is CH1) before link the camera mount
to the servo axis, and confirm the servo neutrality point, then installation as above picture.
Prepare the parts
DCS2600Digi
Digital Servo
1
2
3
STEP 5
Connect the rolling actuating arm with the rolling control arm
1
2
3
1. Do not apply too much force when rotate or press
the damper output shaft, which may break the parts
2. Do not drip the adhesive into the damper output
shaft, it may break the parts
3. Using proper adhesive if there is any loose at
damper joints, but the adhesive could not be dripped
into damper output shaft
4. If you find it is difficult to install the parts due to
the size of the hole, you can enlarge it suitably
