QUICK-START GUIDE
Full manual available to download from: www.Helion-RC.com
Full manual available to download from: www.Helion-RC.com
11
Switch ON your IKONNIK ET3
transmitter and ensure the LED is
lit solid red and that no alarms are
audible. Ensure that the CH2 EPA
dials are turned fully clockwise
and that the D/R (steering rate)
dial is centered. Ensure, also, that
the CH1 and CH2 (trim) dials are
centered at zero.
12
Slide your finger under te dust
cover, locate the switch and
turn ON your Conquest. In the
unlikely event that the car does
not operate, see the PAIRING /
BINDING instructions at the back
of this guide.
13
Check the operation of the throttle
and steering. Pulling the throttle
trigger back will drive the car
forward, pushing the trigger forward
once will apply the brakes while
pushing the trigger forward twice
will drive the car in reverse. Turning
the wheel to the right will cause the
car to turn right and vice versa.
14
Use the throttle and steering trim
dials to fine-tune the controls of
your car. In doing so, ensure that
your Conquest tracks in a straight
line. Also that it doesn’t creep
forwards or backwards at zero
throttle.
Replace the body and secure it
with the four body clips.
10
LED
CH2 EPA
D/R
CH1 &
CH 2
Trim
