Turn OFF ESC and
Transmitter
Press and hold the
SET button then
Turn ON the ESC
RED LED flashes
indicating you are in
program mode
GREEN LED flashes
1 time to set Item 1
Program Item 1:
Running Mode
RED LED flashes to indicate set
value: 1-2, press button to cycle
through available values
GREEN LED flahes
2 times to set Item 2
Program Item 2:
Drag Brake Force
Program Item 3:
LVC Threshold
Program Item N:
“Programmable Item”
RED LED flashes to indicate set
value 1-8, press button to cycle
through available values
RED LED flashes to indicate set
value 1-6, press button to cycle
through available values
RED LED flashes to indicate set
value 1-X, press button to cycle
through available values
GREEN LED flahes
3 times to set Item 3
Continue to cycle through available Programmable Items and set values as desired. We recommend
you start with the default values and adjust only one value at a time to be sure the change has
made the desired effect.
GREEN LED flahes
“N” times to set Item N
HOLD SET BUTT
ON
HOLD SET BUTTON (3 Seconds)
HOLD SET BUTTON (3 Seconds)
HOLD SET BUTTON (3 Seconds)
HOLD SET BUTTON (3 Seconds)
Turn OFF ESC at an
y time t
o confirm se
tting, turn ON again t
o
begin using the ne
w se
ttings
.
Programmable Items
(Blinks of GREEN LED)
Programmable Value (Blinks of RED LED), Black background = default settings
1
2
3
4
5
6
7
8
1.
Running Mode
Forward
with Brake
Forward/
Reverse
with Brake
2.
Drag Brake Force
0%
5%
10%
15%
20%
25%
30%
40%
3.
Low Voltage Cut-Off
Threshold
No
Protection
2.6V/
Cell
2.8V/
Cell
3.0V/
Cell
3.2V/
Cell
3.4V/
Cell
4.
Start Mode/Punch: Higher
value is more aggressive
Level 1
(70%)
Level 2
(80%)
Level 3
(90%)
Level 4
(100%)
5.
Maximum Brake Force
25%
50%
75%
100%
OPTIONAL ACCESSORIES FOR YOUR REAKTOR BRUSHLESS SYSTEM
1. To assist with programming your ESC we offer an LED based program box that when connected will give a digital read-
out of the current Item being programmed and the value. It will also allow you to modify these settings right on the
box. You can purchase this program box at your local hobby dealer as part number RDNA0032. The program box com-
municates with the ESC through the fan port. You must disconnect the fan and plug in the program box. Simply plug in
the program box and program with normal sequence but using box instead of counting flashes and beeps. Remember
to plug the fan back in when you are done.
NOTE: If you are planning to run in a lot of water, it is recommended to disconnect the fan from the ESC. Running the fan
in water will cause excess load on the fan and ESC and may cause permanent damage to the ESC and fan.
PROGRAMMING PROCESS
13
1/10th SCALE 2WD
MONSTER TRUCK