PRECAUTIONS WHEN USING RADIO CONTROLLED PRODUCTS
INTRODUCING THE IKONNIK XENON HRS3.2 2.4GHz RADIO SYSTEM
4
Please read and understand the following instructions for
your new radio system prior to operation to ensure the saf-
est and most enjoyable experience.
• Your model can cause serious damage or injury so please use caution and courtesy when operating your model.
• Do not expose the radio system to water or excessive moisture.
• As a safety precaution, perform all transmitter and receiver adjustments with the vehicle’s wheels off the ground. This
ensures the complete control over the vehicle at all times during adjustments.
• Ensure your batteries (both transmitter and vehicle) have been properly charged for use with your model.
• Keep track of the time the system is in use so you will know how long you can safely operate the transmitter batteries.
• Check all servos and electrical connections prior to each run.
• Do not operate your model near traffic, bystanders, parking areas, or any other area that could result in injury to
people or damage to property.
• If at any time during the operation of your model you observe any erratic or abnormal behavior of your model, immedi-
ately stop operation and bring the mode to a safe stop in a safe location to diagnose the problem.
• Always power on your transmitter before turning your vehicle on.
• If you have little or no experience operating R/C models, we strongly recommend you seek the assistance of your local
hobby dealer.
R/C models are an extremely fun hobby, but safety should never be ignored or taken lightly. Always take caution when op-
erating your model as damage to property and injury can result from careless operation. Please consult your local hobby
dealer with any questions or troubleshooting issues. And of course don’t forget to have fun, you deserve it after reading
through all of these safety tips!
1. Steering wheel: controls left/right motion (designed to
be operated with right hand).
2. Throttle trigger: controls forward/reverse/brake motion
(designed to be operated with left index finger).
3. Handle: For holding the transmitter (designed to be
held with left hand).
4. Antenna: Transmits signal to the receiver located in the
vehicle.
a. Flip up when transmitter in use. Folded position is
only for storage.
5. ON/OFF Switch: Turns the power ON/OFF for the trans-
mitter only.
6. Multifunction red Indicator LED:
a. Power indicator
b. Low battery voltage warning, batteries should be
replaced/recharged before continued use when
flashing.
7. REV/Pair:
a. Use to reverse servo/channel operation.
b. Use to put the transmitter into pairing mode.
8. Digital Trim: All switches are digital so there is no need
to readjust trim position for different models after initial
setup.
a. Steering: Controls the “hands-off” left/right direc-
tion of the vehicle.
b. Throttle: Adjusts the motor speed to STOP when trig-
ger is in “hands-off” (neutral) position.
9. Dual Rate Adjustment Switch: Adjusts total travel of
servo
10. Battery compartment: houses [4] AA batteries for pow-
ering the transmitter. Also has connector for recharge-
able NiMH battery pack.
11. Battery door: Closes the battery compartment, contain-
1
2
3
4
8
a
12
7
8
b
10
5
6
9
11
Steering
Wheel
Throttle
Trigger
Pair/REV
Fail Safe
(CH3)
Steering Trim
(ST- / ST+)
Throttle Trim
(TH- / TH+)
Antenna
Power LED
Reset Button
Beginner Mode /
Feature Lock Out
Power Switch
Handle / Grip
Steering Rate
(DR- / DR+)
Battery Compartment
Install 4 AA batteries ( included) prior to use.
Always allign pos. (+) and neg. (-) polarities properly!
Battery Door
14
13
