Helion Invictus 10MT, Owner'S Manual And Exploded Views

PRECAUTIONS WHEN USING THE HRS-3.1 RADIO SYSTEM

INTRODUCING THE HRS-3.1 2.4GHz RADIO SYSTEM

4

Please read and understand the following instructions for your 
new radio system prior to operation to ensure the safest and 
most enjoyable experience.

Features:

•  Your model can cause serious damage or injury so please use caution and courtesy when operating your model.
•  Do not expose the radio system to water or excessive moisture.
•  As a safety precaution, perform all transmitter and receiver adjustments with the vehicle’s wheels off the ground. This ensures 

the complete control over the vehicle at all times during adjustments.

•  Ensure your batteries (both transmitter and vehicle) have been properly charged for use with your model.
•  Keep track of the time the system is in use so you will know how long you can safely operate the transmitter batteries.
•  Check all servos and electrical connections prior to each run.
•  Do not operate your model near traffi c, bystanders, parking areas, or any other area that could result in injury to people or dam-

age to property.

•  If at any time during the operation of your model you observe any erratic or abnormal behavior of your model, immediately stop 

operation and bring the mode to a safe stop in a safe location to diagnose the problem.

•  Always power on your transmitter before turning your vehicle on.
•  If you have little or no experience operating R/C models, we strongly recommend you seek the assistance of your local hobby 

dealer.

R/C models are an extremely fun hobby, but safety should never be ignored or taken lightly. Always take caution when operating 
your model as damage to property and injury can result from careless operation. Please consult your local hobby dealer with any 
questions or troubleshooting issues. And of course don’t forget to have fun, you deserve it after reading through all of these safety 
tips!

1.  Steering wheel: controls left/right motion (designed to be 

operated with right hand).

2.  Throttle trigger: controls forward/reverse/brake motion 

(designed to be operated with left index fi nger).

3.  Handle: For holding the transmitter (designed to be held with 

left hand).

4.  Antenna: Transmits signal to the receiver located in the 

vehicle.

a.  Flip up when transmitter in use. Folded position is only 

for storage.

5.  ON/OFF Switch: Turns the power ON/OFF for the transmitter 

only.

6.  Multifunction red Indicator LED:

a. Power indicator
b.  Low battery voltage warning, batteries should be re-

placed/recharged before continued use when fl ashing.

7. REV/Bind:

a.  Use to reverse servo/channel operation.
b.  Use to put the transmitter into binding mode.

8.  Digital Trim: All switches are digital so there is no need to 

readjust trim position for different models after initial setup.

a.  Steering: Controls the “hands-off” left/right direction of 

the vehicle.

b.  Throttle: Adjusts the motor speed to STOP when trigger 

is in “hands-off” (neutral) position.

9.  Dual Rate Adjustment Switch: Adjusts total travel of servo

10.  Battery compartment: houses [4] AA batteries for powering 

the transmitter. Also has connector for rechargable NiMH 
battery pack.

11.  Battery door: Closes the battery compartment, containing 

the AA batteries or rechargable battery pack.

12.  Fail Safe setting and Channel 3 toggle.

4

12

1

5

6

2

7

9

8a

8b

10

11