Helipal SRD250 User Manual Download

Page: 9 / 9

FAQ
Lost connection with radio controller

you’re the drone cannot response to the radio controller stick travel, the connection between

radio controller and receiver may lost and you can try to re-bind them by following the procedure
below:

Use the small screwdrivers to press and hold the switch inside the receiver until it is flashing with
light in

Green

, Switch on the radio controller, it will start searching for available receiver. You can

try toggle Switch A to test the buzzer function to determine whether they are bind or not.

Summary of Contents for SRD250

Page 2: ...and parameter setup 2 Always fly the drone away from unsafe conditions such as obstacles crowds high voltage lines etc 3 Do not use in bad weathers such as rainy day snow windy more than moderate bre...

Page 3: ...Camera and Transmitter 2 Storm T6EU 6 Ch Radio System 3 6pcs Clockwise HQ 5040 Tri Blade Prop ABS Propeller 4 of them are spare parts 4 6pcs Counter Clockwise 6045 ABS Propeller 4 of them are spare pa...

Page 8: ...e supported channels of you FPV reception devices such as monitor goggle Frequency Table Frequency Switch 123456 Frequency Switch 123456 5645MHz 001100 5805MHz 001110 5665MHz 101100 DEFAULT SETTING 58...

Page 9: ...controller and receiver may lost and you can try to re bind them by following the procedure below Use the small screwdrivers to press and hold the switch inside the receiver until it is flashing with...