8
Copyright@2015 HeliPal.com. All Rights Reserved
FAQ
Lost connection with radio controller
If
you’re the drone cannot response to the radio controller stick travel, the connection between
radio controller and receiver may lost and you can try to re-bind them by following the procedure
below:
Press the switch inside the receiver
twice
with small screwdrivers to make LED indicator turns
PURPLE
to set the
control mode to D Bus Mode. (
Skip this step if it is default in Purple light
)
Use the small screwdrivers to press and hold the switch inside the receiver until it is flashing with light in
Blue
and
Purple
, Switch on the radio controller, it will start searching for available receiver. Receiver will stop flashing while the
bind process complete and the radio controller will the signal strength on the screen
