35
ACO platform features
Beside the unique DSP sound effects the
DSP ULTRA provides a bunch of new system fea
-
tures.
In the DCM menu of the DSP PC-Tool software in-
dividual settings can be made for several of these
system features.
Turn On & Off Delay
This function allows to determine the delay time with
which the DSP is switched on and off. The factory
setting is 0.2 seconds. The delay time should only
be modified if there are e.g. noises while switching
on / off the signal processor.
URC Setup Switch Configuration
The ACO provides ten internal memory locations for
sound setups instead of the common two.
By using an optional URC remote control or the
Con-
trol pushbutton
it is possible to toggle between two
of the ten memory locations. These two memory lo-
cations can be determined in the “URC Setup Switch
Configuration”. The memory locations one and two
are preassigned ex works. To switch between all
internal memory locations, the optionally available
DIRECTOR display remote control or the HELIX
WIFI CONTROL is recommended.
Remote Output Configuration
This function controls if the remote output (which
switches on and off the connected amplifiers) will
be temporarily deactivated during a sound setup
switch. This function is activated (ON) ex works.
ADEP.3 Configuration
If the DSP ULTRA is connected to an OEM radio via
the highlevel inputs it may happen that the ADEP.3
circuit has to be adapted to the diagnostic mode of
the radio if the latter is equipped with a so-called
“class SB” output stage”.
The ADEP.3 circuit should be adjusted if there are
e.g. distortions in the upper volume range.
The compatibility mode is disabled ex works.
