Connection to a PC
1
Load and save
2
Main menu
3
Channel configuration
4
Highpass filter
5
Lowpass filter
6
Time alignment
7
Output level
8
Frequency graph
9
Range of frequency graphs
10
Equalizer
11
EQ fine adjustment
8
1
6
3
4
7
5
2
9
10
11
25
It is possible to freely configure the HELIX
P SIX DSP MK2 with our DSP PC-Tool software.
The user interface is designed for easy handling of
all functions and allows an individual adjustment of
each of the eight DSP channels. Prior to connect-
ing the amplifier to your PC visit our website and
download the
latest version of the DSP PC-Tool
software
.
Check from time to time for software updates.
You will find the software and the respective user
manual on
www.audiotec-fischer.com
.
We strongly recommend to carefully read the user
manual (Sound Tuning Magazine) before using the
software for the first time in order to avoid any com
-
plications and failures.
Important:
Make sure that the amplifier is not con
-
nected to your computer before the software and
USB driver are installed!
In the following the most important steps how to
connect and the first start-up are described:
1.
Download the latest version of the
DSP PC-Tool software (available on our web-
site
www.audiotec-fischer.com
) and install it
on you computer.
2.
Connect the amplifier to your computer using
the USB cable that is included in delivery. If you
have to bridge longer distances please use an
active USB extension cable with integrated re-
peater and no passive extension.
3.
Turn on the amplifier and start the software after
the
Status LED
lights up green. The operating
software will be updated automatically to the
latest version if it is not up-to-date.
4.
Now you are able to configure your HELIX
P SIX DSP MK2 amplifier with our intuitive
DSP PC-Tool software. Nevertheless interest-
ing and useful hints can be found e.g. in our
“Sound Tuning Magazine”, which can be down
-
loaded for free from our website.
Important:
We highly recommend to set the vol-
ume of you car radio to minimum position during
first start-up. Additionally no devices or speakers
should be connected to the amplifier until general
settings in the DSP PC-Tool software have been
made. Especially if the P SIX DSP MK2 will be used
to drive fully active speaker systems, a wrong setup
can destroy your tweeters right away.
