119 / 179
The reproduction, distribution and utilization of this document as well as the communication of its contents to others without
express authorization is prohibited. Offenders will be held liable for the payment of damages.
All rights reserved in the event of the grant of patent, utility model or design.
21.04.2020
Version 1.18.0
Configuration
APS-90, APS-180 and APS-90-Outdoor-PoE
■
To activate the recording of counting data tick the
Record Counting Data
checkbox
■
To define the period within which counts are accumulated and new data lines are
attached to the current data file set a
Accumulation Interval
Choose a rate between 1 min and 15 min from the drop down list.
■
To define the period for a data file set a
Completion Interval
(Fig. 119 /7). After this
period each data file is completed. New data is recorded in a subsequent file.
Choose an interval between 15 min and 1 day from the drop down list.
■
To activate the recording of zone monitoring data tick the
Record Zone Monitoring
Data
■
To define the period for a data file set a
Completion Interval
(Fig. 119 /2). After this
period each data file is completed. New data is recorded in a subsequent file.
Choose an interval between 15 min and 1 day from the drop down list.
■
To active the recording of wireless tracking data tick the
Record Wireless Tracking
Data
■
To define the period for a data file set a
Completion Interval
(Fig. 119 /4). After this
period each data file is completed. New data is recorded in a subsequent file.
Choose an interval between 15 min and 1 day from the drop down list.
■
To go back to the last saved settings click the
Reset
■
To save all the settings in the device click the
Save
6.9.4
Data File Access
The device can save the counting, zone monitoring and wireless tracking data to CSV files
and automatically upload the completed files.
Fig. 120: Data File Access
To activate the automatic upload tick the
File Upload
