127 / 179
The reproduction, distribution and utilization of this document as well as the communication of its contents to others without
express authorization is prohibited. Offenders will be held liable for the payment of damages.
All rights reserved in the event of the grant of patent, utility model or design.
21.04.2020
Version 1.18.0
Configuration
APS-90, APS-180 and APS-90-Outdoor-PoE
■
If the wireless USB adapter is attached to the sensor at startup and is working, the
WiFi Device State
<up>
.
■
If the Bluetooth USB adapter is attached, the
Bluetooth Device State
shows
<up>
.
■
Using the WiFi Mode WiFi HMI Access or WiFi Data Interface some additional network
information are displayed. The Hostname (Fig. 129 /1), WiFi MAC Address
(Fig. 129 /2), WiFi IP Address (Fig. 129 /3) and the Subnet Mask (Fig. 129 /4) is dis-
played in both modes.
■
The DNS Server (Fig. 129 /5) and NTP Server (Fig. 129 /6) is displayed in WiFi Data
Interface mode.
6.11.2 WiFi Mode
The APS can use the wireless USB adapter in different modes.
Fig. 130: WiFi Mode
■
To deactivate the wireless USB adapter choose the WiFi Mode
Off
■
To track wireless devices such as mobile phones choose the WiFi Mode
WiFi Tracking
■
To access the sensor via WiFi choose the WiFi Mode
WiFi HMI Access
■
To send counting data to a wireless network choose the WiFi Mode
WiFi Data Inter-
face
■
To go back to the last saved settings click the
Reset
■
To save all the settings in the device click the
Save
