129 / 179
The reproduction, distribution and utilization of this document as well as the communication of its contents to others without
express authorization is prohibited. Offenders will be held liable for the payment of damages.
All rights reserved in the event of the grant of patent, utility model or design.
21.04.2020
Version 1.18.0
Configuration
APS-90, APS-180 and APS-90-Outdoor-PoE
6.11.4 WiFi HMI Access
Set up the details for use as an access point:
Fig. 132: WiFi HMI Access
■
To access the HMI with wireless devices choose the WiFi Mode
WirFi HMI Access
■
To choose legal frequency spectrum select your region code ("US" = USA or "DE"=Ger-
many) at the
Regulatory Domain
drop down list (Fig. 132 /14). Default region code
00
is used for worldwide roaming - and uses only a legal and restricted subset of all - so
it will not use all of the local possible frequencies.
■
To identify the sensor WiFi access point set a
SSID
■
For save access set a
Password
(Fig. 132 /12). The default is
<People_Sensor>
.
■
Select a WiFi
Channel
■
Set the IP address for the access point (Fig. 132 /10).
■
To define the logical network segment of your network set a AP Netmask
■
To make the SSID name invisible to others activate
Hide SSID
■
To allow only stored MAC addresses to have access to the device activate
Use MAC
Filter
■
By activating
Use MAC Filter
the editing of MAC addresses becomes visible. To add a
MAC address set the address in the field (Fig. 132 /1) and click the accept button
■
To remove a MAC address from the list (Fig. 132 /4) click the delete button
■
To go back to the last saved settings click the
Reset
■
To save all the settings in the device click the
Save
