139 / 179
The reproduction, distribution and utilization of this document as well as the communication of its contents to others without
express authorization is prohibited. Offenders will be held liable for the payment of damages.
All rights reserved in the event of the grant of patent, utility model or design.
21.04.2020
Version 1.18.0
Configuration
APS-90, APS-180 and APS-90-Outdoor-PoE
6.13.8 Factory reset
Fig. 148: Factory Reset
■
Under certain circumstances it might be necessary to reset all the parameter settings
of the device to their factory default settings.
■
To reset the parameters to the default settings of the installed firmware version click
Start Factory Reset
■
Follow the instructions. After reboot, the user interface usually opens up automati-
cally to enable further configuration. This doesn't happen with network setting
changes.
■
A factory reset can also be done using the reset button or reset pin on the I/O-port
(
Chapter 3.1.5 Factory reset button/pin on page 23).
6.14
About
To go to the
General Information
page click the About icon (Fig. 149 /1).
Fig. 149: Service Tools
The
About
category gives system information. Combined with
Diagnosis Data
,this can be
very useful for customer support purposes.
