Setting up the antenna
HELLASSAT Point&Play Setup Manual - page 35
Version 1.2 - May 2008
2
Loosen securing bolts (1) and (2).
3
Use the hex key to rotate the eccentric E (3) until the letters E on the eccentric and the
masthead point towards each other, as shown in the figure above.
4
While keeping the eccentric E in this position (with the hex key), set the dish to the elevation
you found in the document. Bolt (2) indicates the elevation. In the figure above, the elevation
is set to 49°.
You can now remove the hex key from the eccentric E.
5
Secure bolts (1) and (2).
It is recommended
not
to secure the eccentric E (as you may damage it by doing so).
1
10
20
30
40
50
60
E
3
3
E
2
