Introduction
Version 1.2 - May 2008
HELLAS SAT Point&Play Setup Manual - page 6
Cautions
A
caution
refers to an action or situation that could result in
equipment damage or
destruction
if you do not follow the instructions.
IPmodem
- Always use the in-line power supply with the IPmodem. Using a different power supply may
cause equipment damage.
- To ensure regulatory and safety compliance, use only the provided power and interface cables
or cables which conform to the specifications within this manual.
- Do not open the unit. Do not perform any servicing other than that contained in the installation.
Refer all servicing to qualified service professionals.
- Avoid damaging the IPmodem with static, by first touching the coaxial cable connector when it
is attached to the earth grounded coaxial cable outlet. Always first touch the coaxial cable
connector on the HELLAS SAT IPmodem when you are disconnecting or re-connecting your
Ethernet cable from the HELLAS SAT IPmodem or your PC.
- To prevent overheating, do not block the ventilation holes on the sides and top of the unit.
- Only wipe the IPmodem with a clean, dry cloth. To avoid equipment damage, never use fluids
or similar chemicals. Do not spray cleaners directly on the unit or use forced air to remove dust.
- Install an AC surge arrestor in the AC outlet to which the IPmodem is connected. This will avoid
damage to the equipment by local lightning strikes and other electrical surges.
Point&Play™ tool
- Ensure that the volume of the Point&Play™ tool is not set too loudly, otherwise damage to your
hearing may occur.
